Joyner JNSZ650DL Owner's Manual page 51

above 1 as to obtain the hole position shown by Figure 53.
4) Insert the screwdriver into the hole, turn the drive of oil pump shaft until
parallel to the crankshaft (See Figure 62,Figure 63)
Figure 62
5) Align the mark 2 on the shaft of distributor to the mark 1 on the aluminum
housing (See Figure 63)
6) Insert the distributor slowly to the hole (See Figure 64). Confirm the direction
of distributor is as per the figure (See Figure 65,Figure 66). Tighten the nut of
distributor housing.
Figure 61
Figure 63
Figure 64