RadioLink T7F-2.4Ghz Instruction Manual page 5

H:Throttle - hold switch - This switch operates to hold the engine in the idling position and disengage it from the
Throttle Stick. It is commonly use to practice auto-rotation.
Neck strap hook - Mounting point for optional neck strap.
Aileron/elevator control stick - Operates the servos connected to channel 1 (aileron) and channel 2 (elevator) in the
receiver.
Trim levers (all) - Used to shift the neutral or center position of each servo as labeled in the diagram. Once either trim
lever is operated, the trim position is displayed on the LCD screen. Also once either edit key is operated, all trim
positions are displayed sequentially on the LCD screen.
NOTE: The throttle trim lever is intended for fine tuning the throttle servo when the engine is at idle. Throttle trim does
not affect the throttle servo when the throttle control stick is all the way up (so idle r.p.m. can be adjusted without
affecting throttle settings through the rest of the stick movement).
Charging jack - Port for charging the transmitter batteries.
POWER switch-power on/power off
DATA "+" or "-" key - Used to change the values of the various functions displayed on the LCD screen
Liquid - crystal display screen (LCD) - Displays programming modes and values entered.
MODE "▲"or"▼" key - Used to scroll through and display the different functions.
Press MODE "▲" key to scroll to previous function menu.
Press MODE "▼" key to scroll to next function menu
SELECT key - Used to scroll the sub-menu for the current function.
Throttle/rudder control stick - Operates the servos connected to channel 3 (throttle) and channel 4 (rudder) in the
receiver.
Trainer switch - Operates the trainer functions. To operate as a trainer switch the transmitter must be connected to
another transmitter via. a trainer cord (available separately).
Idle - up switch - This switch operates to change the fight condition which sets the throttle curve and pitch curve of
mid air maneuvers (rolls, loops, stall turns) and 3D flight.
A:Retractable landing gear switch/Channel 5 - Switch operates the servo connected to channel 5 in the receiver. If
your model has retractable landing gear, this is the control used to extend and retract the gear.
H:Gyro switch/Channel 5 -
gyro, which has two different senses. Also if you use the RadioLink GY100 Gyro, two different gyro sense settings on
the gyro function in this transmitter can be called by this switch.
Antenna - Radiates signals to the receiver. NEVER point at the model when flying!
You can connect the sense adjust connector to channel 5 of the receiver to operate the
5