Swsh Swashplate Types Selection & Swash Afr - RadioLink T7F-2.4Ghz Instruction Manual

Gyro mixing function is used for adjusting the gain of the gyro. Select from two different gain settings using a switch on the
transmitter.
To set the GYRO mixing:
1. Plug the gyro's sensitivity adjustment to channel 5 of the receiver. (not assignable)
2. EPA of channel 5 to set 100% both UP and DOWN.
3. Enter the programming mode and use the MODE"▲"or"▼" key to access the "GYRO"
function.
4. Press the DATA "+" key. This will cause the flashing "INH" display to change to a
flashing "ON" display. Now the mixing is on.
5. Press the SELECT key once. This will show the gyro gain setting and flashing "%"
symbol on the display.
Flip the gyro (CH5) switch up and down. This will cause the arrow on the display to point up and down corresponding to
the switch position. Press DATA "+" or "-" key to set the gyro gains for both switch up and down position. Gyro gain can be
adjust from -100% to +100%
SWSH Swashplate types selection & Swash AFR (HELI only)
This function can select from two swashplate types. Swash AFR can be set, if
you choose 3-S type
1-S: Independent aileron, pitch and elevator servos linked to the swashplate.
Most kits are 1-S type.
3-S: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and
right; with Elevator inputs, the three servos tilt the swashplate fore and aft; with
Pitch inputs, all three servos raise the swashplate up and down.
Example of sensitivity setting with RadioLink GY-100
Sensitivity
switch
(CH5)
Relationship
between transmitter set value
and gyro sensitivity
Transmitter
set value sensitivity
+100%
AVCS mode
80%
50%
0%
-50%
Normal mode
60%
-100%
23
Gyro
100%
50%
0%
50%
100%