I/O Terminal Block; Lens Installation And Adjustment - EverFocus EAN Series User Manual

4.2

I/O Terminal Block

The I/O terminal block, located on the rear panel of the camera, can be used to develop application
for alarm input and output.
1 2 3 4
Pin Assignment
No. Function
1
2
4.3

Lens Installation and Adjustment

You can install either a CS-mount or a C-mount lens into the camera. It is recommended to use a lens
with aperture ratio of F/1.4 or smaller. Please refer to the following reference steps.
CS-Mount Lens:
1. Remove the cover cap from the camera body.
2. Install the lens into the camera body.
3. Adjust the lens using the Focus / Zoom Screws.
If you are using a DC Auto Iris lens:
1. Remove the cover cap from the camera body.
2. Install the lens into the camera body.
3. Connect the DC cable to the DC Auto Iris Lens Connector.
No. Function
Alarm COM 3
Alarm Output 4
DC Auto Iris Lens Connector
Alarm Input
Digital GND
Focus Screw
Zoom Screw
C-Mount Lens Adapter
5
EAN Series