Setting Up The Playback Function; Preparing The Micro Sd Card; Testing The Playback Function - EverFocus EAN Series User Manual

6.2

Setting up the Playback Function

Note that the Playback function will not be active until the user has inserted a micro SD card in the
camera's micro SD card slot. The card may also have to be formatted in the Settings submenu.
Micro SD Card Slot
6.2.1

Preparing the Micro SD Card

Once you insert a functional micro SD card into the slot, the Playback button on the Live page should
become active within seconds (see section 6.2.2 below – the grey letters should turn white). IF NOT,
do the following:
1. From the Live page, click Settings > System > SD Card. If no card has been inserted yet, the
Remove button should be faded, indicating that no card is being detected. (If a card is
inserted, and the Remove button is still faded, pull the card out and re-insert it.)
2. Slide the card into the slot until it clicks into position.
3. The Remove button should become active within a few seconds, indicating the card is active.
4. If the Remove button stays faded, click the Format button to format the card. NOTE: All data
on the disk will be deleted if the Format button is clicked.
6.2.2

Testing the Playback Function

1. Once the SD card is detected by the system, the button
will turn to
2. To test the Playback function (this is not required), set up a "Manual Trigger" Recording
Event by clicking Settings > Event > Event Settings.
3. Click the "Add" button on the middle right side of the page to open an "Add Event" box.
4. Give the event a name, like "Test 1".
(active).
19
EAN Series
(inactive)