Dubbing A Tape - Sony DCR-TRV38E Service Manual

Dubbing tape

Dubbing a tape

Before operation for connecting with the A/V connecting cable
•Set DISPLAY in
•Press the following buttons to make the indicator disappear so that they will not be
superimposed on the edited tape:
On your camcorder:
DISPLAY/BATTERY INFO, DATA CODE
On the Remote Commander:
DISPLAY, DATA CODE, SEARCH MODE
The POWER switch should be set to
(1) Insert the blank tape (or the tape you want to record over) into the VCR, and
(2) Prepare the VCR for recording. If the VCR has an input selector, set it to input
(3) Play back the recorded tape on your camcorder.
(4) Start recording on the VCR.
When you have finished dubbing the tape
Press x on both your camcorder and the VCR.
If your VCR is a monaural type
Connect the yellow plug of the A/V connecting cable to the video input jack and the
white or the red plug to the audio input jack on the VCR or the TV. When the white
plug is connected, the left channel audio is output, and when the red plug is connected,
the right channel audio is output.
If your VCR has an S video jack
See page 44 for details.
About i.LINK
See page 194 for details.
Pictures processed by picture effect, digital effect or PB ZOOM
These are not output through the DV Interface.
If you record a paused playback picture
•The recorded picture becomes rough with the DV Interface.
•The picture may jitter when you play back the picture using other video equipment.
If you connect with the i.LINK cable
Recording of only the picture or sound cannot be done.
76
to LCD in the menu settings. (The default setting is LCD.)
insert the recorded tape into your camcorder.
mode.
Refer to the operating instructions of the VCR.
Refer to the operating instructions of your VCR.
.