Sony DCR-TRV38E Service Manual page 86

Dubbing only desired scenes – Digital program editing (on tape)
Step 2: Setting the VCR to operate
To connect using the A/V connecting cable, send the control signal by infrared rays to
the remote sensor on the VCR.
The POWER switch should be set to
Operate by touching the panel.
(1) Turn the power of the connected VCR on.
(2) Press FN to display PAGE1.
(3) Press MENU to display the menu.
(4) Select VIDEO EDIT in
(5) Select TAPE, then press EXEC.
(6) Press EDIT SET.
(7) Select CONTROL, then press EXEC.
(8) When connecting with the A/V connecting cable, select IR, then press EXEC.
(9) Select IR SETUP, then press EXEC.
(10) Select the IR SETUP code of your VCR, then press EXEC. Check the code in
4
OTHERS
DATA CODE
BEEP
COMMANDER
D I SPL AY
V I DEO ED I T
7
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP
PAUSEMODE
I R TEST
78
If the VCR has an input selector, set it to input mode.
When you connect a video camera recorder, set its power switch to VCR/
VTR.
When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to
"Step 3: Adjusting the synchronization of the VCR" on page 81.
"About the IR SETUP code" (p. 80).
5
EXIT
RETURN
TAPE
MEMORY
EXEC RET.
9
END
I R
i. L I NK
EXEC RET.
.
, then press EXEC (p. 177).
V I DEO ED I T
0:32:30:14
MARK START ED I T UNDO
I N SET
TOTAL 0:00:00:00
SCENE 0
END
V I DEO ED I T END
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP 3
PAUSEMODE
I R TEST
EXEC RET.
6
V I DEO ED I T
ED I T SET
CONTROL I R
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP
PAUSEMODE
I R TEST
EXEC
END
RET.