Charging The Battery Pack - Sony DCR-TRV38E Service Manual

Step 1 Preparing the power source

Charging the battery pack

Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
See page 192 for details of "InfoLITHIUM" battery pack.
(1) Install the battery pack on your camcorder.
(2) Connect the AC Adaptor supplied with your camcorder to the DC IN jack with
(3) Connect the power cord to the AC Adaptor.
(4) Connect the power cord to a wall outlet.
(5) Set the POWER switch to OFF (CHG).
When the remaining battery time indicator changes to
To fully charge the battery pack (full charge), leave the battery pack attached for about
one hour after normal charge is complete until the FULL indicator appears in the
display window. Fully charging the battery pack allows you to use the battery pack
longer than usual.
3
After charging the battery pack
Disconnect the AC Adaptor from the DC IN jack on your camcorder.
16
the DC plug's v mark facing up.
Charging begins. The remaining battery time is indicated in minutes in the
display window.
, normal charge is complete.
2 5
VCR
OFF(CHG)
CAMERA
MEMORY/
NETWORK