Table of Contents
Advertisement
3.
Whether all of the jumpers are set correctly in the hard drive
6-1-8 FLOPPY DISK CONTROLLER ERROR OR NO
CONTROLLER PRESENT
When you cannot find or initialize the floppy drive controller, please ensure the
controller is in proper BIOS Setup. If there is no floppy drive installed, ensure
the Diskette Drive selection in Setup is set to NONE.
6-1-9 KEYBOARD ERROR OR NO KEYBOARD
PRESENT
When this situation happens, please check keyboard attachment and no keys
being pressed during the boot. If you are purposely configuring the system
without a keyboard, set the error halt condition in BIOS Setup to HALT ON ALL,
BUT KEYBOARD. This will cause the BIOS to ignore the missing keyboard and
continue the boot procedure.
6-1-10 MEMORY ADDRESS ERROR
When the memory address indicates error, you can use this location along with
the memory map for your system to find and replace the bad memory chips.
6-1-11 MEMORY SIZE HAS CHANGED
Memory has been added or removed since last boot. In EISA mode, use
Configuration Utility to re-configure the memory configuration. In ISA mode
enter BIOS Setup and enter the new memory size in the memory fields.
6-1-12 MEMORY VERIFYING ERROR
It indicates an error verifying a value is already written to memory. Use the
location along with your system's memory map to locate the bad chip.
Korenix | Technical Reference
57
Advertisement
Table of Contents
