Table of Contents
Advertisement
32 Bit Data Transfer
This option sets the 32-bit data transfer option. The Optimal and Fail-Safe default
setting is enabled.
4-2-2-3 Hard Disk Write Protect
Set this option to protect the hard disk drive from being overwritten. The Optimal
and Fail-Safe default setting is disabled.
Available Options: Disabled, Enabled
Default setting: Disabled
4-2-2-4 IDE Detect Time Out (Sec.)
Set this option to stop the AMIBIOS from searching for IDE devices within the
specified number of seconds. Basically, this allows you to fine-tune the settings to
allow for faster boot times. Adjust this setting until a suitable timing that can detect
all IDE disk drives attached is found.
Available Options: 0, 5, 10, 15, 20, 25, 30, and 35
Default setting: 35
4-2-2-5 ATA(PI) 80 Pin Cable Detection
Set this option to select the method used to detect the ATA (PI) 80 pin cable. The use
of an 80-conductor ATA cable is mandatory for running Ultra ATA/66, Ultra ATA/100
and Ultra ATA/133 IDE hard disk drives. The standard 40-conductor ATA cable cannot
handle the higher speeds.
Available options: Host & Device, Host, and Device
Default setting: Host & Device
4-2-3 SuperIO Chipset – Configuration
Win627 Super IO Chipset
This section describes the function of Super I/O settings.
26
BIOS | Korenix
Advertisement
Table of Contents
