Boot Up Num-Lock; Ps/2 Mouse Support; Wait For 'F1' If Error; Hit 'Del' Message Display - Korenix JetBox 8180 User Manual

4-4-3 Boot Up Num-Lock

This field is used to activate the Num Lock function upon system boot. If the setting is
on, after a boot, the Num Lock light is lit, and user can use the number key.
Available options: On, Off
Default setting: On

4-4-4 PS/2 Mouse Support

The PS/2 mouse function is optional. Before you configure this field, make sure
your system board supports this feature. The setting of Enabled allows the system to
detect a PS/2 mouse on boot up. If detected, IRQ12 will be used for the PS/2 mouse.
IRQ 12 will be reserved for expansion cards if a PS/2 mouse is not detected.
Disabled will reserve IRQ12 for expansion cards and therefore the PS/2 mouse will
not function.
Available options: Disabled, Enabled and Auto
Default setting: Auto

4-4-5 Wait for 'F1' If Error

AMIBIOS POST error messages are followed by:
Press <F1> to continue
If this field is set to Disabled, the AMIBIOS does not wait for you to press the <F1>
key after an error message.
Available options: Disabled, Enabled
Default setting: Disabled

4-4-6 Hit 'DEL' Message Display

Set this field to Disabled to prevent the message as follows:
Hit 'DEL' if you want to run setup
It will prevent the message from appearing on the first BIOS screen when the
computer boots.
36 BIOS | Korenix