Table of Contents
Advertisement
jumber setting of hardware installation.
Chapter 6 Technical Reference
6-1
Trouble Shooting for Post Beep and Error
Messages
The following information informs the Post Beep & error messages. Please adjust
your systems according to the messages below. Make sure all the components and
connectors are in proper position and firmly attached. If the errors still exist, please
contact with your distributor for maintenance.
6-1-1 POST BEEP
Currently there are two kinds of beep codes in BIOS setup.
One indicates that a video error has occurred and the BIOS cannot
initialize the video screen to display any additional information. This
beep code consists of a single long beep followed by three short beeps.
The other indicates that an error has occurred in your DRAM. This beep
code consists of a constant single long beep.
6-1-2 CMOS BATTERY FAILURE
When the CMOS battery is out of work or has run out, the user has to replace it with
a new battery.
6-1-3 CMOS CHECKSUM ERROR
This error informs that the CMOS has corrupted. When the battery runs weak, this
situation might happen. Please check the battery and change a new one when
necessary.
Korenix | Technical Reference
55
Advertisement
Table of Contents
