Table of Contents
Advertisement
3-3
HW Installation
Before Installation
Before you install the system, make sure you follow the following descriptions.
1. Before removing the cover, shut down the operation System and disconnect
power switch to off and unplug AC-to DC Adapter cable.
2. Install any connector, Compact Flash, and hard disk is sure that the power is
disconnected or power switch to off from the system. If not, this may
damage the system.
3. The ESD (Electricity Static Discharge) may be created from human body that
touches the board. It may do damage to the board circuit.
Removing Covers –Installing Hardware
If you are installing hardware option, you can remove the front and back cover. The
following figure will guide you how to install 2.5" HDD inside, Compact Flash modules,
DDR2-RAM module, miniPCIe module & SIM card.
a. Unscrew front cover and Installing Compact Flash
Korenix | Hardware Feature
15
Advertisement
Table of Contents
