4-4-1 Boot Setting Configuration
4-4-2 Quick Boot
This field is used to activate the quick boot function of the system. When set to
Enabled,
1.
BIOS will not wait for up to 40 seconds if a Ready signal is not received from the
IDE drive, and will not configure its drive.
2.
BIOS will not wait for 0.5 seconds after sending a RESET signal to the IDE drive.
3.
You cannot run BIOS Setup at system boot since there is no delay for the Hit, Del.
To run Setup message.
Available Options: Disabled, Enabled
Default setting: Enabled
Korenix | BIOS
35