Table of Contents
Advertisement
Securing the M-Series AIO to a Mounting Bracket
Use the four pre-tapped holes to secure the touchcomputer to the mounting
bracket. The holes are designed to work with ISO metric M4 screws. Mounting
screws are not included. Select the length screw that will provide adequate thread
engagement to provide a reliable connection to the mounting bracket. The correct
length screw for your application should be commonly available at a hardware
store. Refer to the figure below for the location of the 4 holes.
Mounting Diagram
VuPoint™ M-Series Touchcomputer User Guide 19
Advertisement
Table of Contents
