Chapter 3
General Mounting Information
The holes located on the sides and top of the touchmonitor case are for ventilation. Do not
block, cover, or insert anything inside the ventilation slots.
Rear VESA Mount
A four-hole 100x100mm mounting pattern for M4 screws (7mm) is provided on the rear of
the monitor. Remove the stand using a Phillips screwdriver to access this mounting
interface. The VESA FDMI-compliant mounting is coded: VESA MIS-D, 100, C
For use only with UL Listed Wall Mount Bracket or equivalent
All manuals and user guides at all-guides.com
Mounting
.
U e Man al: 1915L
SW600066 Re J, Page 14 of 37