Names And Functions Of The Operating Section - Daikin BRC7E530W User Manual

OH12-01
Do not leave the remote controller
wherever there is a risk of wetting.
If water gets into the remote controller
there is a risk of electrical leakage and
damage to electronic components.
When using the wireless remote con-
troller, do not put a strong light beam or
install an inverter fluorescent lamp near
the receiving section on the main unit.
A malfunction may occur.
Watch your steps at the time of air fil-
ter cleaning or inspection.
High-place work is required, to which
utmost attention must be paid.
If the scaffold is unstable, you may fall or
topple down, thus causing injury.
2. NAMES AND FUNCTIONS
OF THE OPERATING SEC-
TION (Fig. 1, 2)
DISPLAY "
SION)
1
This lights up when a signal is being
transmitted.
DISPLAY "
" " (OPERATION MODE)
This display shows the current OPER-
2
ATION MODE. For cooling only type,
" " (Auto) and "
not installed.
H
DISPLAY "
3
This display shows the set temperature.
DISPLAY "
hr.
(PROGRAMMED TIME)
4
This display shows PROGRAMMED
TIME of the system start or stop.
DISPLAY "
5
Refer to page 9.
DISPLAY "
6
The display shows the set fan speed.
English
Control Systems
" (SIGNAL TRANSMIS-
" " " " " " "
" (Heating) are
M L
" (SET TEMPERATURE)
C
"
hr.
" (AIR FLOW FLAP)
" " " (FAN SPEED)
Remote Controller (Wireless Type)
DISPLAY " TEST
(INSPECTION/ TEST OPERATION)
7
When the INSPECTION/TEST OPER-
ATION BUTTON is pressed, the display
shows the system mode is in.
ON/OFF BUTTON
Press the button and the system will
8
start. Press the button again and the
system will stop.
FAN SPEED CONTROL BUTTON
9
Press this button to select the fan
speed, HIGH or LOW, of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPER-
10
ATURE (Operates with the front cover
of the remote controller closed.)
PROGRAMMING TIMER BUTTON
Use this button for programming
11
"START and/or STOP" time. (Operates
with the front cover of the remote con-
troller opened.)
TIMER MODE START/STOP BUTTON
12
Refer to page 10.
TIMER RESERVE/CANCEL BUTTON
13
Refer to page 10.
AIR FLOW DIRECTION ADJUST BUTTON
14
Refer to page 9.
OPERATION MODE SELECTOR BUTTON
15
Press this button to select OPERATION
MODE.
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE
16
in the operation manual attached to the
indoor unit.
INSPECTION/TEST OPERATION
BUTTON
17
This button is used only by qualified
service persons for maintenance
purposes.
EMERGENCY OPERATION SWITCH
18
This switch is readily used if the remote
controller does not work.
"
4
3P107422-1S
161
2