Names And Functions Of The Operating Section - Daikin BRC082A41W Operation Manual

Names and functions of the
operating section
See figure 1, (figure 1B shows the remote controller with
front cover opened)
1 DISPLAY " " (SIGNAL TRANSMISSION)
This lights up when a signal is being transmitted.
2 DISPLAY " " " " "
MODE)
This display shows the current OPERATION MODE.
3 DISPLAY " " , "
This display shows the set temperature.
4 DISPLAY "
This display shows PROGRAMMED TIME of the system
start or stop.
5 DISPLAY "
" (SWING FLAP)
Refer to "AIR FLOW DIRECTION ADJUST" on page 5.
6 DISPLAY " " " " "
The display shows the set fan speed.
7 DISPLAY " " (INSPECTION/TEST OPERATION)
When the INSPECTION/TEST OPERATION BUTTON is
pressed, the display shows the system mode is in.
8 ON/OFF BUTTON
Press the button and the system will start. Press the
button again and the system will stop.
9 FAN SPEED CONTROL BUTTON
Press this button to select the fan speed, LOW, MEDIUM
or HIGH, of your choice.
10 TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
11 TIMER MODE START/STOP BUTTON
Refer to "TIMER MODE START/STOP" on page 6.
12 TIMER RESERVE/CANCEL BUTTON
Refer to "PROGRAMMING TIME" on page 6.
13 AIR FLOW DIRECTION ADJUST BUTTON
Refer to "AIR FLOW DIRECTION ADJUST" on page 5.
14 OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
15 FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE in the operation
manual attached to the indoor unit.
16 INSPECTION/TEST OPERATION BUTTON
This button is used only by qualified service persons for
maintenance purposes.
2
" " " " " (OPERATION
" (SET TEMPERATURE)
" (PROGRAMMED TIME)
" (FAN SPEED)
See figure 3, (receiver on decoration panel)
17 EMERGENCY OPERATION SWITCH
This switch is readily used if the remote controller does
not work.
18 RECEIVER
This receives the signals from the remote controller.
19 OPERATION LAMP (Red)
This lamp stays lit while the air conditioner runs. It blinks
when the unit is in trouble.
20 TIMER LAMP (Green)
This lamp stays lit while the timer is set.
21 AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
Lights up when it is time to clean the air filter.
22 DEFROST LAMP (Orange)
Lights up when the defrosting operation has started.
„ For the sake of explanation, all indications are
NOTE
shown on the display in figure 1 contrary to
actual running situations.
„ If the AIR FILTER CLEANING TIME
INDICATOR lamp lights up, clean the air filter
as explained in the operation manual provided
with the indoor unit.
After cleaning and reattaching the air filter,
press the FILTER SIGN RESET button
on the remote controller. The AIR FILTER
CLEANING TIME INDICATOR lamp on the
receiver will go out.
„ The DEFROST lamp will blink when the power
is turned on. This is not a malfunction.
■
English