Remote Controller (Wireless Type)
(3) Receiver installation
1. As shown at right, pass the harness from the receiver through the
wiring hole of the decoration panel. Then, attach the receiver to
the decoration panel.
2. Hook the harness from the receiver on the upper part of the
panel temporary suspension of the decoration panel.
Be sure to push the harness to the groove.
3. Attach the decoration panel to the indoor unit.
(Refer to the installation manual attached to the decoration panel.)
4. Connect the harness from the receiver to the connector X1A on the transmitter board.
After connecting, use the attached clamp to fix the two harnesses to the transmitter board box.
5
176
Panel temporary suspension
Clamp
OH12-01
English
3P107423-1B
Control Systems