Configure The Decoder Trigger; Configure The Ascii Commands - Allen-Bradley 2755-SN3 Application Manual

2–6 Using ASCII Command Input
Publication 2755-6.8

Configure the Decoder Trigger

This section defines ASCII Command Input 1 as the trigger for the
reader's decoder.
1. Click the Decoder button from the main Project dialog.
2. Under Triggered By, select ASCII Command Input 1 from the
Input list.
3. Click the Save button.
4. Click the Close button and return to the main Project dialog.

Configure the ASCII Commands

The following procedure defines the ASCII commands that will
trigger the decoder to start/stop scanning.
1. Click the Input/Output button on the main Project dialog.
2. Under Inputs & Outputs, select ASCII Command Input 1.