Connecting The Scanner To A Decoder - Allen-Bradley 2755-HUG-4 User Manual

Connecting the Scanner to a Decoder

The scanner interface cable connects to the input port of the decoder.
The following table summarizes the cable and connectors required for
each decoder.
ATTENTION: Do not install or remove the scanner
cables or connectors until the power to the scanner and
!
decoder is turned off. Failure to follow this caution may
result in damage to the scanner or decoder.
ATTENTION: Make sure you use the Series B Gun
Adapter (Catalog No. 2755-NC16, Series B). If you are
!
ugrading from an earlier version Allen-Bradley hand-held
scanner (such as the 2755-G2 or -G3) which used the
Series A gun adapter, you will need to purchase the series
B gun adapter.
Note: A Gun Adapter (Catalog No. 2755-NC16)
may be required to connect the scanner to some
Series B decoders.
Decoder Type
Bulletin 2708-DH5
Attended WorkStations
Multi-Purpose
Bar Code WorkStation
(Catalog No. 2755-DH1)
Single or Dual-Head
Enhanced Bar Code Decoder
(Catalog No. 2755-DS1A, -DD1A)
2–3
2755-NC16
Series B
Gun Adapter
No
No
Required
Publication 2755-6.1