Fault Messages - Allen-Bradley 2755-SN3 Application Manual

17–24 Communicating with PanelView 900t Terminals on a DeviceNet Network
Code
Client Object Failed. No way to force this. Should not occur
17
under normal operating conditions.
CAN Chip Failed to initialize. Should not occur under normal
18
operating conditions.
The channel size of a particular channel exceeds the size
37 limitations set by the daughtercard. Should not occur under
normal operating conditions.
Critical Internal DeviceNet Firmware fault. Should not occur
20xx
under normal operating conditions.
Errors Internal faults associated with motherboard/daughtercard
9, 10, communications. Should not occur under normal operating
11, 21, conditions.
22, 24,
25, 26,
27, 28,
29, 30,
31, 32,
34, 35,
and 36
Publication 2755-6.8

Fault Messages

These messages indicate critical fault conditions. They appear as a
full screen box with an Error #635 in the upper left corner. The
terminal must be reset to clear the condition. If the problem persists,
Allen-Bradley should be contacted and the two digit code number
associated with the error noted.
Indicates Recommended Action(s)
Reset the terminal and if the problem reoccurs, consult
Allen-Bradley.
Reset the terminal and if the problem reoccurs, consult
Allen-Bradley
Reset the terminal and if the problem reoccurs, consult
Allen-Bradley.
Reset the terminal and if the problem reoccurs, consult
Allen-Bradley.
Reset the terminal and if the problem reoccurs, consult
Allen-Bradley.