Preface; Contents Of This Guide - Allen-Bradley 2755-SN3 Application Manual

P–2

Preface

Contents of this Guide

Publication 2755-6.8
The following table describes the contents of this manual.
Chapter Title
Preface
Using the Auto-Load
1
Function
Using ASCII Command
2
Input
Downloading Match
3
Codes from a Host Device
Downloading Match
Codes via DH485
Protocol with an
4
t
SLC 5/03 or
t
SLC 5/04 Controller
Communicating with a
5
1746-BAS BASIC Module
Communicating with an
t
6
SLC over an RS-232
Link
Communicating with an
7 SLC on a DH-485
Network
Communicating with an
PLC-5 R over an RS-232
8
or RS-422 Link
Communicating with an
SLC 5/03 Processor on a
9
t
DeviceNet Network
Communicating with an
SLC 5/03 Processor on a
10
DeviceNet Network using
Explicit Messaging
Communicating with a
11 PLC-5 Processor on a
DeviceNet Network
Table continued on the next page.
Contents
Describes the purpose, background, and scope of
this guide. Also specifies the audience for whom
this guide is intended.
Describes how to configure the reader to autoload
data into the match code table.
Shows how to configure the reader to start/stop
scanning when receiving ASCII commands from a
terminal emulator and then display the bar code
data on the emulator.
Shows how to download match codes (and other
host commands) from a terminal emulator to the
reader.
Shows how to download match codes from an
SLC 5/03 or SLC 5/04 controller to the reader.
Describes how to configure the reader to
communicate with a 1746-BAS BASIC module.
Describes how to configure the reader to
communicate with an SLC controller over an
RS-232 serial connection.
Tells how to configure two readers to communicate
with an SLC controller over a DH-485 network
using master mode.
Describes how to configure the reader to
communicate with an PLC controller using either
RS-232 or RS-422 communication.
Shows how to configure a reader to communicate
with an SLC controller over a DeviceNet network in
master/slave mode.
Shows how to configure a reader to communicate
with an SLC controller over a DeviceNet network in
master/slave mode using explicit messaging.
Shows how to configure a reader to communicate
with a PLC-5 controller over a DeviceNet network in
master/slave mode.