Dialogic Diva Installation Manual page 66

International Regulatory Information
IMPORTANT: This equipment will be inoperable when mains power fails.
• This customer equipment shall only be installed in a PC that requires the
use of a tool to gain access to internal parts (e.g., this customer equipment
must not be installed in a PC with a "flip lid").
• Proper installation of the Dialogic
screwed to the metal backplate of the computer. This ensures proper
grounding, which is necessary for safety purposes.
• This customer equipment may only be installed in host equipment where
there is at least 2 mm of air gap between the customer equipment and
adjacent boards (PCBs).
• Only compliant line cord set(s) shall be used as replacements with this
customer equipment.
These products shall be used in a manner that complies with the technical
standards ACA TS 001 and ACA TS 002:
• The application software shall answer an incoming call by seizing the line
at least 2 seconds after the start of an application of ring signal from a
PSTN. A maximum time of 15 seconds is recommended.
• The application software shall comply with the following requirements
before the commencement of dialing:
• When dial tone detection is enabled, the application software may
commence dialing after the presence of dial tone is validated.
• If dial tone detection is not enabled or if dial tone is not detected, the
application software shall commence dialing no less than 2 seconds
after the line is seized.
• A total of 10 call attempts are allowed to a telephone number, with a
minimum period of 2 seconds between calls. If the call does not connect
after 10 attempts, 30 minutes must expire before automatic redialing may
be initiated.
• These products must connect to the telecommunications network only by
means of cables that meet applicable ACA standards and
telecommunications conformity.
page 66
® ®
Diva Media Board requires that it is