Dialogic Diva Installation Manual page 33

RJ10 connector
® ®
Dialogic Diva Analog-4 Media Boards:
Diva Analog-4 Media Boards have four RJ11 ports for connecting four separate
analog lines. You can use any port; typically, you must specify the port number
during software configuration. The port numbers are shown below. The
diagram is oriented with the edge connector pointing downwards.
Connect your Diva Analog-4 Media Board as follows:
1. Take the four cables included with the Diva
Media Board and plug the RJ10 connectors into
the board.
Diva Analog
Media Board
Contact assignments (plugs and jacks):
RJ10
Pin 2 Ring
Pin 3 Tip
Dialogic® Diva® Media Board Installation Guide
RJ11 connector
Port 1
Port 2
Port 3
Port 4
2. Plug the RJ11 connectors into the wall
jack or PBX.
Signals RJ11
Pin 3
Pin 4
1 6
Wall jack or PBX
page 33