Dialogic Diva Installation Manual page 34

Installation
Note: Looking at the RJ10 and RJ11 connector with the exposed connector
pins facing you, the pins are numbered from 1 to 4 and 1 to 6 from left to
right as shown below.
RJ10 connector
® ®
Dialogic Diva Analog-8 Media Boards:
Diva Analog-8 Media Boards have four RJ45 ports for connecting four dongles.
The dongles have two ports each for connecting two separate analog lines;
therefore, you can connect to up to eight analog lines. You can use any port;
typically, you must specify the port number during software configuration. The
port numbers are shown below. The diagram is oriented with the edge
connector pointing downwards.
Connect your Dialogic
1. Take the four cables with the dongle and plug the
RJ45 connectors into the Diva Media Board.
Diva Analog
Media Board
2. Take the eight cables and
plug the RJ10 connectors into the
dongle. The jack labeled with "A"
corresponds to the ports 1,3,5, and 7.
The jack labeled with "B" corresponds
to the ports 2,4,6, and 8.
page 34
Port 1 and Port 2
Port 3 and Port 4
Port 5 and Port 6
Port 7 and Port 8
® ®
Diva Analog-8 Media Board as follows:
Wall jack or PBX
3. Plug the RJ11 connectors
into the wall jack or PBX.
RJ11 connector
1 6