Dialogic Diva Installation Manual page 65

The equipment must be installed such that with the exception of the
connections to the host, clearance and creepage distances shown in the table
below are maintained between the Dialogic
assemblies which use or generate a voltage shown in the table below.
Clearance Creepage
X mm Y mm
2.0 2.4 (3.8)
2.6 3.0 (4.8)
4.0 5.0 (8.0)
4.0 6.4 (10.0)
The larger distance shown in brackets applies where the local environment
within the host is subject to conductive pollution or dry non-conductive
pollution which could become conductive due to condensation. Failure to
maintain these minimum distances would invalidate the approval.
The clearance distance X is the shortest distance in air between two points.
The creepage path Y (along surfaces) is the shortest distance between the
same two points.
Regulatory information for Australia
Dialogic is required to provide the following information as a condition of the
telecommunications conformity of Dialogic
You may also be responsible for meeting requirements other than those
outlined in this document.
Note: Failure to meet the requirements listed may render the products
non-compliant, with the user liable to significant penalties under the
Telecommunications Act.
WARNING: This customer equipment is to be installed and maintained by
service personnel as defined by AS/NZS 60950.1:2011
Service Personnel. It may be hazardous if your computer is
not properly plugged in and grounded.
CAUTION: This equipment must be installed and serviced by qualified
personnel. No user accessible parts inside.
Dialogic® Diva® Media Board Installation Guide
® ®
Diva Media Board and any other
Voltage used or generated by other
parts of the host or expansion card
Vrms or Vdc
up to 50
up to 125
up to 250
up to 300
®
telecommunications products.
page 65