Subscribe to Our Youtube Channel
Related Manuals for Gefen EXT-DVI-1CAT6-GI
Summary of Contents for Gefen EXT-DVI-1CAT6-GI
- Page 1 *Preferred 3GSDI Audio Embedder DVI over 1 CAT6 w/ Galvanic Isolator EXT-DVI-1CAT6-GI User Manual Release A2...
- Page 2 Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this product near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Page 3 Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notified within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifications.
-
Page 4: Technical Support
Technical Support (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday, Pacific Time (818) 772-9120 Email support@gefen.com http://www.gefen.com Mailing Address Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 91311 Product Registration Register your product here: http://www.gefen.com/kvm/Registry/Registration.jsp... - Page 5 DVI over 1 CAT6 w/ Galvanic Isolator is a trademark of Gefen, LLC. © 2014 Gefen, LLC. All Rights Reserved. All trademarks are the property of their respective owners. Gefen, LLC reserves the right to make changes in the hardware, packaging, and any accompanying documentation without prior written notice.
-
Page 6: Packing List
The DVI over 1 CAT6 /w Galvanic Isolator ships with the items listed below. If any of these items are not present in the box when you first open it, immediately contact your dealer or Gefen. • 1 x DVI over 1 CAT6 w/ Galvanic Isolator (Sender unit) •... -
Page 8: Table Of Contents
Table of Contents Getting Started Introduction......................2 Sender unit ....................2 Receiver unit ....................4 Installation ......................6 Connection Instructions ................. 6 Sample Wiring Diagram ................6 Basic Operation DIP Switch Configuration ..................10 Default Settings ................... 10 EDID Management ..................11 Color Management .................. -
Page 11: Getting Started
DVI over 1 CAT6 w/ Galvanic Isolator Getting Started Introduction......................2 Sender unit ....................2 Receiver unit ....................4 Installation ......................6 Connection Instructions ................. 6 Sample Wiring Diagram ................6... -
Page 12: Introduction
Introduction Page Title Sender unit EXT-DVI-1CAT6-GIS Gefen EXT-DVI-1CAT6-GIS Gefen EXT-DVI-1CAT6-GIS Gefen Link Link Link over 1 CAT6 w/ Galvanic Isolator S over 1 CAT6 w/ Galvanic Isolator S over 1 CAT6 w/ Galvanic Isolator S Power DVI In 5V DC... - Page 13 Introduction Page Title Name Description Link Connect a CAT-5e cable (or better) from this port to the Link port on the Receiver unit. 5V DC Connect the included 5V DC power supply to this power receptacle. Power This LED will glow bright blue once the included 5V DC power supply has been properly connected between the locking power receptacle and an available...
-
Page 14: Receiver Unit
Introduction Page Title Receiver unit EXT-DVI-1CAT6-GIR Gefen EXT-DVI-1CAT6-GIR Gefen EXT-DVI-1CAT6-GIR Gefen Link Link Link over 1 CAT6 w/ Galvanic Isolator R over 1 CAT6 w/ Galvanic Isolator R over 1 CAT6 w/ Galvanic Isolator R 5V DC Power DVI Out... - Page 15 Introduction Page Title Name Description Link Connect a CAT-5e cable (or better) from this port to the Link port on the Sender unit. 5V DC Connect the included 5V DC power supply to this power receptacle. Power This LED will glow bright blue once the included 5V DC power supply has been properly connected between the locking power receptacle and an available...
-
Page 16: Installation
The grounding terminal must be permanently connected to an approved Earth ground by wiring not less than 16 AWG. Sample Wiring Diagram Galvanically Isolated CAT-5e or CAT-6A CABLE DVI CABLE Receiver DVI Source (such as a Medical Imaging Camera) Sender DVI Display EXT-DVI-1CAT6-GI page | 6... -
Page 19: Basic Operation
DVI over 1 CAT6 w/ Galvanic Isolator Basic Operation DIP Switch Configuration ..................10 Default Settings ................... 10 EDID Management ..................11 Color Management ..................11 Adjusting the Signal Quality ................12... -
Page 20: Dip Switch Configuration
DIP Switch Configuration On the bottom panel of the Sender unit is a bank of 4 DIP switches. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management and color depth. DIP switches 3 and 4 are not used. Default Settings The following table lists the default (factory) settings of each DIP switch. -
Page 21: Edid Management
DIP Switch Configuration EDID Management The DVI over 1 CAT6 w/ Galvanic Isolator can be switched between two EDID modes: Internal or Pass-through. After changing DIP switch 1, the Sender unit must be power-cycled for changes to take effect. DIP Switch 1 Description Pass-through mode. -
Page 22: Adjusting The Signal Quality
Adjusting the Signal Quality The Receiver unit of the DVI over 1 CAT6 w/ Galvanic Isolator has a trim pot that is used to equalize the output signal, compensating for extension distance and cable skew. If there is no output video or if output video contains video artifacts and/or video noise such as snow, over 1 CAT6 use the steps below to adjust the trim pot. -
Page 25: Appendix
DVI over 1 CAT6 w/ Galvanic Isolator Appendix Surface Mounting Instructions ................16 Specifications ...................... 17... -
Page 26: Surface Mounting Instructions
Surface Mounting Instructions The Sender and Receiver units can be mounted on any flat surface, as shown below (screws not included). There should be an inch or two of clearance between the edges of the unit and any walls or vertical surfaces to allow for enough clearance for connection and disconnection of the DVI cables. -
Page 27: Specifications
Specifications Connectors & Indicators Video Input (Sender) • 1 x DVI 29-pin, female (digital only) Video Output (Receiver) • 1 x DVI 29-pin, female (digital only) Link (Sender / Receiver) • 1 x RJ-45 Power (Sender / Receiver) • 1 x Locking-type Power Indicator (Sender / Receiver) •... - Page 28 *Preferred Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 1-800-545-6900 818-772-9100 818-772-9100 fax: 818-772-9120 fax: 818-772-9120 www.gefen.com www.gefen.com support@gefen.com support@gefen.com...
Need help?
Do you have a question about the EXT-DVI-1CAT6-GI and is the answer not in the manual?
Questions and answers