Yardworks 060-3999-2 Instruction Manual page 27

model no. 060-3999-2 | contact us: 1-866-523-5218
PROBLEM POSSIBLE CAUSE
Then handle is not The bolts are not properly seated.
in position.
The switch is defective.
The snow thrower
The extension cord is not connected to
does not start.
the plug.
The extension cord is not connected to
the power source.
The motor is on,
The belt is damaged.
but the impeller
does not turn.
The scraper is worn.
The snow thrower
leaves a thin layer
of snow behind.
SOLUTION
Make sure the bolts are correctly installed through the
handle bars. Check to see if the hand knobs are tight.
Refer to Assembling the Handle section in this manual.
Have the switch replaced by an authorized service
center.
Connect the plug on the snow thrower to the
extension cord.
Plug the extension cord into a live 120 V AC, 60 Hz
outlet.
Replace the belt (see the section entitled Inspecting/
Replacing the Drive Belt).
Inspect the scraper for wear or damage.
Replace the scraper (see the section Replacing the
Scraper).
27