Replacing The Scraper - Yardworks 060-3999-2 Instruction Manual

model no. 060-3999-2 | contact us: 1-866-523-5218

REPLACING THE SCRAPER

The scraper is located at the bottom of the impeller housing.
1. Ensure that the snow thrower is not plugged in.
2. Remove the screw (1) from each side plate that holds the scraper and 3 screws (2) from under the
machine that secures the scraper to the machine.
3. Remove and discard the old scraper.
4. Install the new scraper, and fasten it securely with the 5 screws that you previously removed.
WARNING: If the extension cord is plugged into the snow
!
thrower, the snow thrower could start accidentally while the
operator is performing maintenance on it, which could cause
serious personal injury. Disconnect the extension cord before
performing any maintenance.
1
2
1
23