Denso BHT-8000 User Manual page 11

Proper Care of the BHT and CU
Wipe the BHT's charge terminals and battery cartridge terminals with a cotton swab or the like
periodically. Clean the BHT housing with a dry, soft cloth. Before cleaning, be sure to turn the BHT off.
• Never use benzene, alcohol, or other organic solvents. The housing
may be marred or the paint may come off.
• Never rub or strike the liquid crystal display (LCD) with anything
hard. The LCD surface will be easily scratched or broken.
• When cleaning the keypad, do not scrub the surface too hard or pull
on the keys. Doing so may break the keys.
• If the BHT becomes smudged, moisten a soft cloth with neutral detergent and wring it out thoroughly.
Wipe the BHT with the cloth and then go over it again with a dry cloth.
Dust or dirt accumulating on the clear plate of the bar-code reading window will affect reading
performance. If you use the BHT in dusty areas, therefore, periodically check the clear plate of the bar-code
reading window and clean it if dusty.
• To clean the plate, first blow the dust away with an air brush. Then wipe the plate with a cotton swab or
the similar soft one gently.
• If sand or hard particles have accumulated, never rub the plate; doing so will scratch or damage it.
Blow the particles away with an air brush or a soft brush.
Limited Warranty on Software Products
In no event will DENSO WAVE be liable for direct, indirect, special, incidental, or consequential
damages (including imaginary profits or damages resulting from interruption of operation or loss of
business information) resulting from any defect in the software or its documentation or resulting from
inability to apply the software or its documentation.
ix