Brother RJ-3050 User Manual page 127

Troubleshooting
Problem
Printed barcodes cannot be read.
I want to reset the printer/delete the
data transferred from the computer.
I want to cancel the current print job. Make sure that the printer is ON, and press the
Solution
 Print labels so that barcodes are aligned with the print head as shown
below.
1
2
1 Print head
2 Barcode
3 Printing orientation
Try using another scanner.

 Set [Print Speed] to a slower option. The print speed can be specified in the
"Printer Setting Tool". (See Device Settings on page 66.)
 Adjust [Print Density]. The print density can be specified in the printer
driver's dialog box or the "Printer Setting Tool". (See Device Settings
on page 66.)
 This printer is not designed exclusively for creating barcode labels. Always
check that barcode labels can be read by the barcode reader.
To reset the printer, perform the following procedure:
For RJ-3050
1 Press and hold the (Power) button to turn the printer off.
2 Press and hold the
3 seconds. The POWER, Wi-Fi and Bluetooth indicators start blinking
(POWER: in orange; Wi-Fi and Bluetooth: in blue).
3 While pressing the (Power) button, press the
4 Release the (Power) button.
For RJ-3150
1 Press the [Menu], [ ], or [ ] button to select the [Administration] menu,
and then press the [OK] button. (The default password is "1111".)
2 Select [Reset] > [Factory Reset] > [Reset] using [ ] or [ ], and then
press the [OK] button.
All the transferred data from the computer will be deleted and the printer
settings will be reset to the factory settings.
3
(Feed) button and the (Power) button for about
(Power) button.
(Feed) button 3 times.
118
8