Dim - Yaesu FTDX9000MP Operation Manual

The illumination level of the analog meters, main frequency display, and the LCD display may be reduced, if you are using
the transceiver in a dark environment where high brightness is not desired.
[DIM] Switch
To reduce the illumination level, press the [ DIM ] switch,
located to the left of the leftmost analog meter. To restore
full brightness, press the [ DIM ] switch once more.
You may also customize the amount of brightness reduc-
tion engaged by the pressing of the [ DIM ] switch, and may
use different brightness levels for different front panel
areas. Menu item "DISPLAY 014 DIMMER-METER"
adjusts the brightness level of the analog meters and the
LCD display, while menu item "DISPLAY 015 DIM-
MER-VFD" sets the brightness levels of the main fre-
quency display (these settings are effective only when the
[ DIM ] switch is pressed).
FT 9000MP O
DX PERATION
B B B B B O O O O O
ASIC ASIC ASIC PERA PERA TION PERA TION TION TION
ASIC ASIC PERA PERA TION

DIM

M
ANUAL
: : : : : R R R R R A A A A A
ECEIVING ON ON ON ON ON ECEIVING ECEIVING
ECEIVING ECEIVING
VDD
LCD Display Brightness Adjustment
By following the procedure below, you may adjust
the brightness level of the LCD window.
1. Press the front panel's [ POWER ] switch for
two seconds to switch the main transceiver
power off.
2. Press and hold in the [ SWR ] key while turning
on the transceiver main power (press and hold
in the [ POWER ] switch for two seconds). Once
power comes on, release
the [ SWR ] key; the LCD
window will now be con-
figured for setting of the
brightness level.
3. Rotate the [ CLAR/VFO-B ] knob to set the
brightness level. You can observe the bright-
ness level changing on the LCD window.
4. When you have finished your adjustment, press
the [ SWR ] switch momentarily to save the new
setting.
B B B B B
MA MA MA MA MA TEUR TEUR TEUR TEUR ANDS ANDS ANDS
TEUR ANDS ANDS
BIAS TEMP SWR
Page 49