Using The Monitor - Yaesu FTDX9000MP Operation Manual

C C C C C T T T T T
ONVENIENT ONVENIENT ONVENIENT RANSMITTER RANSMITTER RANSMITTER
ONVENIENT ONVENIENT RANSMITTER RANSMITTER
You may listen to the quality of your transmitted signal using the Monitor feature.
[MONI] Knob
[MONI] Switch
1. Press the [ MONI ] switch. The imbedded Red LED
will light up, indicating that the Monitor is turned
on.
2. During transmission, rotate the [ MONI ] knob to ad-
just the audio level from the Monitor. Clockwise rota-
tion of this knob will increase the volume level.
3. To switch the Monitor off again, press the [ MONI ]
switch once more. The Red LED will go out, confirm-
ing that the Monitor is now disengaged.
Page 102
A A A A A
CCESSORIES CCESSORIES CCESSORIES
CCESSORIES CCESSORIES
U MONITOR
SING THE
VDD BIAS
A A A A A
D D D D D VICE VICE VICE
VICE VICE
If you are using the speaker for monitoring, in-
stead of headphones, excessive advancement of
the [ MONI ] control can cause feedback to oc-
cur. Additionally, this feedback can cause the
VOX system to hang up in a loop, making it
impossible to return to receive. Therefore, we
recommend the use of headphones, if at all pos-
sible, or the minimum usable setting of the
[ MONI ] control, if the speaker must be used.
Because the Monitor feature utilizes a sampling
of the transmitter's IF signal, it can be very use-
ful for checking the adjustment of the Speech
Processor or Parametric Equalizer on SSB, and
for checking the general signal quality on AM,
FM, RTTY, and PKT.
FT 9000MP O
DX
TEMP SWR
M
PERATION ANUAL