Memory Channel Recall - Yaesu FTDX9000MP Operation Manual

M M M M M G G G G G
EMOR Y Y Y Y Y EMOR EMOR R R R R R OUPS OUPS OUPS OUPS
EMOR EMOR OUPS
Press the [ V/M ] key, if necessary, to enter the Memory
1
mode. A memory channel number will appear in the
multi-panel window.
2. Press the [ MCH/GRP ] key momentarily.
The Red LED inside the switch will light up, indicat-
ing that you are ready to recall a memory channel.
A A A A A
:
D D D D D VICE VICE VICE VICE VICE
If the Red LED imbedded in the [ MCH/GRP ] key does
not light up, check to be sure that the orange lamp to
the right of the [ CLAR/VFO-B ] knob is not illumi-
nated. It it is, press the [ A/B ] switch to make it go out,
then press the [ MCH/GRP ] key again.
3. After pressing the [ MCH/GRP ] key, you may rotate
the [ CLAR/VFO-B ] knob to select the desired
memory channel.
Page 128
M C
EMORY HANNEL
To work within a particular Memory Group, press
and hold in the [ MCH/GRP ] key for two seconds.
The imbedded LED will glow Orange; now press
the [ MCH/GRP ] key momentarily, and the LED
will change to Red; you mauy now choose the chan-
nel within the selected Memory Group.
R
ECALL
[V/M] Switch [CLAR/VFO-B] Knob
VDD BIAS
[MCH-GRP] Switch
A A A A A
D D D D D VICE VICE VICE VICE VICE
FT 9000MP O
DX
TEMP SWR
[A/B] Switch
M
PERATION ANUAL