Quick Split Operation - Yaesu FTDX9000MP Operation Manual

C C C C C T T T T T
ONVENIENT ONVENIENT ONVENIENT RANSMITTER RANSMITTER RANSMITTER
ONVENIENT ONVENIENT RANSMITTER RANSMITTER
The Quick Split feature allows you to set a one-touch offset of +5 kHz to be applied to your radio's transmit
frequency on the Sub VFO, compared to the Main (VFO-A) frequency.
1. Start with regular transceiver operation on the Main
(VFO-A) band.
MAIN ( VFO-A )
[ RX ] switch "ON" (LED glows Green)
[ TX ] switch "ON" (LED glows Red)
SUB ( VFO-B )
[ RX ] switch "OFF" (LED Off)
[ TX ] switch "OFF" (LED Off)
2. Press and hold in the [ SPLIT ] switch for two sec-
onds to engage the Quick SPlit feature, and apply a
frequency 5 kHz above the Main (VFO-A) fre-
quency to the Sub (VFO-B) frequency register.
Press and hold in the [ SPLIT ] switch for two sec-
onds to increment the Main (VFO-A) frequency to
+5 kHz.
The VFO configuration will then be:
MAIN ( VFO-A )
[ RX ] switch "ON" (LED glows Green)
[ TX ] switch "OFF" (LED Off)
SUB ( VFO-B )
[ RX ] switch "OFF" (LED Off)
[ TX ] switch "ON" (LED glows Red)
3. Press and hold in the [ SPLIT ] switch for two sec-
onds to increment the Main (VFO-A) frequency
another +5 kHz.
Page 106
A A A A A
CCESSORIES CCESSORIES CCESSORIES
CCESSORIES CCESSORIES
S -F
PLIT REQUENCY

Quick Split Operation

MAIN(VFO-A)
[RX] Switch "ON" [TX] Switch "OFF"
(LED glows Green)
"SPLIT" Indicator
[MAIN Tuning Dial] knob
[SPLIT] Switch
Q Q Q Q Q
1. Press the [ MNU ] key momentarily. The Menu list
2. Rotate the [ MAIN Tuning Dial ] knob to select
3. Rotate the [ CLAR/VFO-B ] knob to select the de-
4. When you have completed all adjustments, press
O
PERATION
MAIN(VFO-A) SUB(VFO-B)
[RX] Switch "OFF"
(LED Off) (LED Off)
VDD
[CLAR/VFO-B] Knob
P P P P P
:
UICK UICK UICK UICK UICK OINT OINT OINT OINT OINT
The operating mode applied to the Sub (VFO-B)
register will be the same as that in use on the Main
(VFO-A) register.
The offset of the Sub VFO from the Main VFO is
programmed via the Menu, and is set to +5 kHz at
the factory. Other offsets may be selected, however,
using the following procedure:
will appear on the LCD display.
Menu item "GENERAL 038 QUICK SPLIT
FREQ".
sired offset.
The available selections are:
–20kHz ~ 0kHz ~ +20kHz
(factory default: +5 kHz).
and hold in the [ MNU ] switch for two seconds to
save the new setting and exit to normal operation.
If you only press the [ MNU ] key momentarily to
exit, any changes you performed will not be stored.
FT 9000MP O
DX
[MNU] Switch
BIAS TEMP SWR
SUB(VFO-B)
[TX] Switch "ON"
(LED glows Red)
M
PERATION ANUAL