Memory Operation On "Regular" Memory Channels; Normal Memory Storage; Memory Channel Recall - Yaesu FT-891 Operating Manual

Memory Operation on "Regular" Memory Channels

Most Memory operation will be conducted in the "regular" memory registers. There are 99
memory channels available for storage and recall of important frequencies.

Normal Memory Storage

1. In the VFO mode, select the desired frequency, repeater shift, CTCSS/DCS tone, and
TX power level.
2. Press the [VuM] key momentarily to enter
the "Memory Check" mode, which is used to
find an unused memory channel. Rotate the
MULTI knob to select the channel number
on which you wish to store the current fre-
quency data.
3. If you just want to program in the frequency data, press and hold in the [VuM] key for
one second until you hear two beeps, a second apart; the second beep confirms that
the frequency information was successfully stored.

Memory Channel Recall

1. Press the [ V/M ] key once to enter the "Mem-
ory" mode.
2. Rotate the MULTI knob, as needed, un-
til Multi Function Row "F-13 [ MCH ] [ GRP ]
[ MLIST ] " appears on the display.
3. Press the [ A ]( MCH ) key, then rotate the
MULTI knob.
4. Press the [ A ]( MCH ) key and then rotate the MULTI knob to select the desired memory
channel.
FT-891 Operating Manual
Application for FCC / IC
FCC ID: K6620651X50 / IC: 511B-20651X50
Memory Operation
23