Table of Contents
Advertisement
UX-A10DVD
Reattaching the Play/ Record & Clear
head
1.
Reattaching the head mount assembly.
1)
Change front of the direction cover of the head
mount assembly to the left(Turn the head forward).
2)
Fit the bosses O',P',Q',U' and V' on the head
mount assembly to the holes P and V, the slots
O,U and Q of the mecha sub assembly(See Fig.11
to 13).
CAUTION:
To remove the head mount assembly,
turn the direction cover to the left to
disengage the gear. If the gear can not
be disengaged easily, push up the boss
Q' slightly and raise the rear side of the
head mounts slightly to return the
direction lever to the reversing side.
2.
Tighten the azimuth screw for reversing.
3.
Reattach the spring from the back of the Play/
Record & Clear head.
4.
Connect the flexible wire to connector CN31 on the
head amplifier & mechanism control board.
1-38
(See Fig.11~13)
Spring
Flexible wire
O'
U'
Head mount assembly
Fig.11
Head mount assembly
O
P Q
V
U
Fig.12
Head
Azimuth screw for reversing
CN31
mechanism control board
Fig.13
P'
V'
Direction cover
Q'
Direction cover
Head mount
Head amplifier &
Advertisement
Table of Contents
