Table of Contents
Advertisement
Removing the feed motor assembly
REFERENCE:
The feed motor assembly can be
performed even if the pickup unit is
attached.
For the white and black harnesses extending from
1.
the feed motor assembly, unsolder two soldering k
on the traverse mechanism board.
Remove the two screws M attaching the feed motor
2.
assembly.
Remove the two screws O attaching the feed motor
3.
bracket.
Removing the traverse mechanism
board
Prior to performing the following procedure, remove the
feed motor assembly.
1.
For the red and black harnesses extending from the
spindle motor, unsolder two soldering l on the traverse
mechanism board.
2.
Remove the screw N .
CAUTION:
When reattaching the traverse mechanism
board, make sure the position of the pickup.
If the pickup is on the most inside position,
move it outward by turning the screw shaft
gear not to contact with the rest SW.
(See Fig.19,20)
Traverse mechanism board
Feed motor assembly
(See Fig.19)
Soldering l
N
Solldering k
M
Rest SW
Fig.19
Feed motor
Feed motor bracket
O
Fig.20
UX-A10DVD
Pickup
Screw shaft gear
1-31
Advertisement
Table of Contents
