Table of Contents
Advertisement
UX-A10DVD
<DVD loading mechanism section>
Removing the clamper assembly
Remove the four screws A attaching the clamper
1.
assembly.
Move the clamper assembly in the direction of the
2.
arrow to release the joint a on each side, and
remove.
ATTENTION:
When reassembling, reattach the
clamper assembly at the two joints a.
Removing the tray
Prior to performing the following procedure, remove
the clamper assembly.
1.
Push the part b of the slide cam through the slot on
the left side of the loading base.
2.
Draw out the tray toward the front.
ATTENTION:
When reattaching the tray, move the
part c of the slide cam to the right(See
Fig.3).
Removing the servo control board
CAUTION:
Solder the sorting round point before
disconnecting the flexible wire extending
from the pickup. If you do not follow this
instruction, the pickup may be damaged.
1.
Solder the sorting round point on the flexible wire
connected to connector CN101 on the servo control
board.
2.
Disconnect the flexible wire from connector CN101
on the servo control board.
3.
Disconnect the card wires from connector CN201
and CN202 on the servo control board.
4.
Release the two joints d.
5.
Move the servo control board in the direction of the
arrow to release the joint e, and remove upward.
CAUTION:
Unsolder the sorting round point after
reassembling.
1-18
(See Fig.1)
A
(See Fig.2,3)
Loading base
(See Fig.4)
Servo control board
a
A
Fig.1
b
Fig.2
Fig.3
CN201
d
e
CN202
CN101
Fig.4
a
A
Clamper
assembly
A
Tray
c
Slide cam
Sorting round point
CN101
Flexible wire
d
Advertisement
Table of Contents
