Table of Contents
Advertisement
Removing the traverse mechanism
assembly
Prior to performing the following procedure, remove
the clamper assembly, the tray and the servo control
board.
1.
Remove the four screws B attaching the traverse
mechanism assembly.
CAUTION:
When reassembling, get the flexible wire
extending from the spindle motor board
through the slot f of the elevator.
Removing the elevator (See Fig.7 and 8)
Prior to performing the following procedure, remove
the clamper assembly, the tray, the servo control
board and the traverse mechanism assembly.
1.
Pull the two tabs g outward and release the two
shafts of the elevator.
ATTENTION:
When reassembling, fit the two shafts
on the front side of the elevator into
the grooves h of the slide cam.
Elevator
Tab g
Loading base
Fig.7
(See Fig.5,6)
Elevator
Tab g
Elevator
B
Traverse mechanism
assembly
B
Fig.5
B
Traverse mechanism
assembly
Fig.6
Shaft
Elevator
Fig.8
UX-A10DVD
B B
B B
B
f
Slide cam
h
1-19
Advertisement
Table of Contents
