UX-A10DVD
<Traverse mechanism assembly section>
<Traverse mechanism assembly section>
Removing the insulator
1.
Removing the insulators from the four notches of the
traverse mechanism chassis.
Removing the pickup unit
1.
Remove the screw K attaching the shaft holder (F) on
the back of the traverse mechanism assembly.
2.
Move the shaft inward and release from the shaft holder
(R).
3.
Bring up the one side of the pickup unit on the shaft to
release the joint j on the opposite side. Then, remove
the pickup unit with the shaft.
Removing the pickup
1.
Pull out the shaft from the pickup.
2.
Remove the two screws L attaching the rack spring
to the pickup.
CAUTION:
Before disconnecting the flexible wire
connected to the pickup, solder the shorting
round point to protect the pickup from static
electricity.
1-30
(See Fig.16)
Insulator
(See Fig.17)
Shaft holder(F)
(See Fig.18)
Pickup unit
Traverse mechanism chassis
Fig.16
Joint j
Pickup guide
Pickup unit
K
Fig.17
L
Rack spring
Pickup
Shaft
Fig.18
Insulator
Shaft holder(R)