Table of Contents
Advertisement
Removing the pickup
1.
Prior to performing the following procedure, remove
the feed motor assembly.
2.
Remove the screw l, the T spring(S) and the shaft
holder with the plate.
ATTENTION:
When reassembling, reattach the T
spring (s) correctly to press the shaft
3.
Detach the part n of the shaft upward and move the
part o in the direction of the arrow, then remove the
shaft from the spindle base.
4.
Release the joint p in the direction of the arrow.
Pull out the shaft from the pickup.
5.
Remove the two screws J attaching the actuator.
6.
Release the joint of the actuator and the lead spring,
and pull out the lead spring.
ATTENTION:
When reattaching the pickup, attach
the spring under the shaft(See the
figure below).
Spring
Removing the shaft holder/ shaft
Prior to performing the following procedure, remove
the feed motor assembly and the pickup.
1.
Remove the screw K attaching the shaft holder.
2.
Remove the shaft.
(See Fig.17,18)
Plate
T spring(S)
Pickup
Pickup
Shaft
(SeeFig.19)
Pickup
p
I
n
Fig.17
J
Actuator
Lead spring
Shaft
Fig.18
Shaft
K
Shaft holder
Fig.19
UX-A10DVD
Spindle base
o
Shaft holder
Actuator
Lead spring
1-23
Advertisement
Table of Contents
