Table of Contents
Advertisement
Pulley gear bracket
Removing the idle gear/ pulley gear/
middle gear/ slide cam
Prior to performing the following the procedures,
remove the clamper assembly, the tray, the servo
control board, the traverse mechanism assembly,
the elevator and the motor assembly.
Push the two tabs j attaching the idle gear inward
1.
and pull out the idle gear.
2.
Remove the screw E attaching the pulley gear
bracket. Move the pulley gear bracket in the direction
of the arrow and remove upward.
3.
Pull out the pulley gear.
4.
Move the slide cam in the direction of the arrow to
release the two joints k and remove upward.
5.
Remove the middle gear.
E
Pulley gear bracket
Pulley gear
Motor assembly
Fig.11
(See Fig.11~13)
Idle gear
E
Idle gear
Pulley gear
Pulley gear
k
Slide cam
Slide cam
Fig.13
UX-A10DVD
Tab j
Middle gear
k
Fig.12
Middle gear
Loading base
1-21
Advertisement
Table of Contents
