Table of Contents
Advertisement
UX-A10DVD
<DVD traverse mechanism assembly>
Removing the feed motor assembly
Unsolder the two soldering l on the spindle motor
1.
board.
Remove the two screws F attaching the feed motor
2.
assembly.
Removing the feed motor
Prior to performing the following procedure, remove
the feed motor assembly.
1.
Remove the screw G and the spring.
CAUTION:
When reassembling, attach the spring
correctly to press the feed gear M and
E.
2.
Remove the feed gear M.
3.
Pull out the feed gear E and the lead screw.
4.
Remove the two screws H and the feed motor.
CAUTION:
When reassembling, set the two wires
extending from the feed motor to the
notch m of the feed holder as shown in
Fig.14.
1-22
(See Fig.14)
(See Fig.14~16)
Feed motor assembly
F
F
m
l
Spindle motor board
Fig.14
Lead screw
Fig.15
Feed motor
Feed motor
Fig.16
Pickup
Spindle motor
Feed gear M
Spring
G
Feed gear E
H
Advertisement
Table of Contents
