JVC UX-A10DVD Service Manual page 20

UX-A10DVD
Removing the motor assembly
Prior to performing the following procedure, remove
the clamper assembly, the tray, the servo control
board, the traverse mechanism assembly and the
elevator.
1. Remove the belt from the pulley.
Remove the screw C attaching the loading motor.
2.
Remove the screw D attaching the motor board on
3.
the back of the loading assembly.
Release the tab i fixing the motor board and remove
4.
the motor assembly.
1-20
(See Fig.9,10)
Tab i
C
Loading motor pulley
Fig.9
D
Motor board
Motor assembly
Fig.10
Belt
Loading assembly