Troubleshooting; Error Notification; The Following Conditions Are Not Malfunctions - Sanyo VW-VF10BG Technical Data & Service Manual

6. Troubleshooting

1. Error notification

The CHECK lamp on the display blinks to indicate an error.
For servicing, contact the dealer where the system was purchased.

2. The following conditions are not malfunctions.

Before requesting servicing, check the following. If the problem is still not corrected, contact the dealer
where the system was purchased.
Trouble
2
No lamps light when the ON/OFF
button is pressed.
The ADD WATER lamp is ON.
The ADD WATER lamp is ON although
there is water in the water tank.
There is an odor in air coming from
the outlet.
There is a chlorine smell when the
system is first used, or when
operation starts.
A bubbling sound can be heard.
A humming sound can be heard.
No air comes out of the outlet.*
The SAVER lamp is ON.
(The fan speed is reduced.)
There is the sound of running water.
* If no air is emitted when 3 minutes have elapsed after the ON/OFF button was pressed, contact the dealer where
the system was purchased.
WARNING
Do not disassemble or modify.
G
Do not disassemble or modify this system. Doing so may result in fire, electric shock, or injury.
Cause
Has the power plug come out of the
socket?
There is no water in the water tank.
Did you press the ON/OFF button
again?
Is old water being used?
(Has the DRAIN lamp been ON
for a long period of time?)
Have the filters or electrolyzed
water tray become fouled?
This is caused by the generation of
electrolyzed water.
This is the sound of water being
supplied from the water tank.
This is the sound of the fan operating.
Have 3 minutes passed since the
ON/OFF button was turned ON?
Is the room humidity 80% or higher?
This is the sound of water draining to
the drainage tank.
2 - 9
Using this System
Correction
Securely insert the power plug all
the way to the base and press the
ON/OFF button.
Add tap water to the water tank, and
press the ON/OFF button again.
Press the ON/OFF button again.
Perform draining and drying.
Clean the intake filter.
The odor will diminish when the
system has operated for some time.
(approximately one-half day)
If the odor does not diminish, change
the electrolysis condition setting.
This is not a malfunction. Continue
to use the system as-is.
The fan will start when approximately
3 minutes have passed.
When the room humidity falls to 70%
or lower, the original fan speed will
be restored.
Dispose of the water in the drainage
tank.