Advertisement
Technical Specification
Input power :
1800W
Input voltage :
230-240V , 50Hz
Protection class:
class ll
Power cord length:
5m
Dust capacity :
2L
Trouble Shooting
If you have a problem with your cleaner, consult the handy guide as below. If
the cleaner is malfunctioning, do not operate it before asking for service.
Problem
Possible Solution
Clean the filter and clean up the inside of the dust cup.
Noisy operation
Clean or replace the filter.
Low Suction
Remove the blockage.
Put the dust cup in place.
Clean the filters, and clean up the inside of the dust cup.
Over-heating/
Check for blockages and unblock and allow it to cool.
Automatically Stopping
Plug unit firmly.
Decrease of the
If the vacuum power decrease, rinse the HEPA filter and
vacuum power
the exhaust filter
Nozzle is clipped into a compartment at the bottom edge
Cannot Find the
on the back of the vacuum cleaner (between the wheels).
Combination Nozzle
It is a single attachment.
Due to the strong suction power, it may be difficult to push,
especially thick carpet. Rather than to use the floor brush
forcibly, lift up the Floor Brush momentarily. It allows air to
Floor Brush hard to
flow into the vacuum releasing and built up suction
push
pressure, and then do well to push floor brush.
Slide and open the suction adjuster located on the hose
handle grip. This will reduce suction power of the floor
head.
Cord doesn't fully
Pull out the cord and rewind again.
rewind
7
Advertisement
