Using The System - Sanyo VW-VF10BG Technical Data & Service Manual

3. Using the System

Plug the power cord into the outlet.
Use a power source that includes a power leakage breaker.
Press and hold this button for 3 seconds in order to engage the child lock. The CHILD LOCK
CHILD
lamp lights. The child lock disables all button controls except for STOP. To cancel the child
LOCK
lock, press and hold this button again for 3 seconds.
This can be used to forcefully
DRAIN
drain the water from inside the
/ DRY system and begin operation to
dry the Virus Washer element.
Press the LOUVER button to
cause the louver to swing.
When the louver has reached
the desired position, press this
AIR
button again to stop the louver.
DIRECTION
The louver will automatically
be fixed in this position the
next time the system is
operated.
The fan speed changes each
MODE
time the FAN SPEED
CHANGE
button is pressed.
CAUTION
1. If the system is used at the HIGH fan speed, the air throughout the room will be purified more quickly.
When the system is first used, it is set to MEDIUM fan speed.
2. Automatic cleaning operation function
Even when this product is stopped, it performs automatic cleaning operation in order to ensure that the inside
of the system remains clean. Because this cleaning operation is started automatically, leave the product
plugged in and make sure there is sufficient water in the water tank when the product is stopped, on
weekends and holidays, and during other brief periods when it will not be operated.
3. The SAVER lamp lights when the room humidity is 80% or higher, and the fan changes to LOW speed.
Winter
HIGH
Approx. 6 hours
MED
Approx. 10 hours
LOW
Approx. 15 hours
(Use an AC 220 – 240 V outlet.)
Important Information
Selecting operation
FILTER
RESET
STARTING
FAN SPEED
STOPPING
Water refill
The times at left are an
approximate guide for
water refill during
winter (at a room
temperature of 20°C
and 30% humidity).
2 - 6
This indicates a guide for when cleaning of the
intake filter and scale filters is necessary. After
cleaning is completed, press and hold the
FILTER RESET button for 3 seconds to turn off
the FILTER lamp.
The fan speed can be checked
on the control section display panel.
Press the ON/OFF
When this button is pressed, the
OPERATION lamp begins blinking and the
system begins preparing for operation (3
minutes). During this preparation, the fan
remains stopped and no air is discharged.
When preparation is complete, the
OPERATION lamp stops blinking and
remains lit, and operation starts.
Press the ON/OFF
If the system does not stop
If the normal method fails to stop the unit,
pull out the power plug and contact the
dealer where the system was purchased.
Summer
HIGH
Approx. 7 hours
MED
Approx. 12 hours
LOW
Approx. 18 hours
Using this System
button.
button.
The times at left are an
approximate guide for
water refill during
summer (at a room
temperature of 27°C
and 47% humidity).
2