Storage (When The System Will Not Be Used For An Extended Period Of Time) - Sanyo VW-VF10BG Technical Data & Service Manual

Cleaning the outlet filter and intake filter
G
Outlet filter
Remove the front upper panel and remove the outlet filter.
Use a vacuum cleaner to remove the dust, then re-install the filter with the top side of the filter facing upwards.
Front upper panel
G
Pre-filter and high collection filter
Remove the front lower panel.
Turn the left and right knobs and remove the two intake filters.
Use a vacuum cleaner to remove the dust, or wash with water.
After washing, dry the filter thoroughly in shade.
Re-install the high collection filter with the side where "TO FACE
FAN" is printed facing toward the unit (the fan).
CAUTION
G
If the surface of the high collection filter is facing the wrong way,
air intake may be impeded, resulting in
lower air discharge and increased noise.
High collection filter
G
After cleaning the filters and returning them to their original positions, press and hold the RESET button for 3
seconds.
The FILTER lamp will turn OFF.
Do not use this system with the filter removed. Doing so may result in malfunction.

9. Storage (when the system will not be used for an extended period of time)

When the system will not be used for an extended period of time
Perform draining and drying. (Refer to the previous section "Draining and Drying Procedure.")
(when dust becomes noticeable or when the FILTER lamp is ON)
Pre-filter
Install with the knobs
facing toward you.
Important Information
2 - 12
Outlet filter
Front lower panel
Knob
Pre-filter
Using this System
Knob
2